My sender was leaking through the screw holes up to the screw head. I used a
screw with an "O" ring to seal the leak. I obtained the screws from Olander
in Sunnyvale.
John
-----Original Message-----
From: Healeys [mailto:healeys-bounces@autox.team.net] On Behalf Of Bob
Spidell
Sent: Sunday, April 26, 2015 9:41 PM
To: Healeys
Subject: [Healeys] Fuel Sender Gasket
Listers,
We have a small problem with our BN2: we can't get the sender unit to
completely seal against the tank. We've tried all types of materials; inc.
the Moss rubber-like gasket, paper gasket material, cork, etc.
This is a new tank and the flange around the opening isn't as robust as on
an original tank, and the flange on the sender has been warped somewhat,
probably by over-tightening. The best result has been from a cork gasket my
dad fabricated, but it still seeps a little with a full tank.
Any suggestions?
TIA,
Bob
_______________________________________________
$12.75
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://autox.team.net/mailman/options/healeys/jmsdarch@sbcglobal.net
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|