Mine has one spacer (approx. 3/16" thick) on each side of the heat shield. I
am no sure this is original. I do recall that the heat shield cannot be
installed (won't lay flat) without a spacer between it & the intake manifolds.
Also, I installed a gasket on each side of each spacer. I.E. 4 gaskets/carb.
Gary Hodson
-----Original Message-----
From: Keith Bailey <keithbailey5@bigpond.com>
To: Healeys <Healeys@autox.team.net>
Sent: Thu, Dec 12, 2013 5:58 pm
Subject: [Healeys] Heat shield
Hi list
Could any BT7 Tri- Carb owner please advise which side of heat shield do the
spacers go
the manuals and part catalogue's appear to give different pictures of the
correct position of the spacers thanking you in anticipation
Cheers Keith
BT6
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://autox.team.net/mailman/options/healeys/warthodson@aol.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|