re: "The box also says that the warranty is void if silicone fluid is used"
So did mine (before I bench bled it with DoT 5 and installed it). No problems
(but I've only got about 25K miles on it).
BTW, who would honor the warranty? Have to send it to England?
Bob
On 6/17/2013 4:40 PM, Bob Haskell wrote:
> All,
>
> I've fitted a new 5/8" brake master cylinder to the tri-carb. The part
> number on the box is PMB120X. I've also
> rebuilt the two front calipers, including the square/quad o-ring between the
> halves. After bleeding the system with
> an eezibleed, the brake pedal still has too much travel. It doesn't go all
> the way to the floor and the travel
> doesn't change after pumping the pedal for a bit. Thoughts?
>
> On the box, it states that the master cylinder must be bench bleed before
> installation. How is this different than
> using the eezibleed?
>
> The box also says that the warranty is void if silicone fluid is used - fwiw.
> I'm using Castrol GTLMA.
>
> Cheers,
>
> Bob Haskell
> AHCA 3000 Mk I registrar
> http://www.ciahc.org/registry_3000mk1.php
> _______________________________________________
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|