Re: [Healeys] Heater hoses

[Bob Spidell <bspidell@comcast.net>]

My bad. I know the breather hoses are larger ID than the heater hoses (the 
breather hoses are 5/8", heater would be 1/2") . 

Three-eighths hose would make our heaters even more anemic. 

bob 


-------------------------------- 
Bob Spidell - San Jose, CA 

----- Original Message -----
From: "Per Schoerner" <healeyguy@bredband.net> 
To: healeys@autox.team.net 
Sent: Wednesday, January 23, 2013 7:21:58 AM 
Subject: Re: [Healeys] Heater hoses 

Simon 
Inner diameter should be 1/2 inch. At the time I replaced mine I could 
only find 13 mm ID. They were a little difficult to get through the 
firewall grommets, but with a little patient, and some soap, it worked. 

Per 

Bob Spidell skrev 2013-01-23 15:19: 
> IRC, it's 3/8" ID hose. If you make the bend radius as l 
_______________________________________________ 
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys