almost sounds like an imploding flexible hose...?
Best
JK
------------------------------
On Thu, Jan 3, 2013 9:38 PM EST john spaur wrote:
>I installed a lightened Denis Welch flywheel and throw-out bearing along with
>BJ8 clutch disk and housing which is all supposed to work together. However
>there are some issues I don't understand.
>
>The first motion shaft will rotate in neutral which I think is normal.
>
>When I depress the clutch pedal (it is bleed properly) I can engage the
>transmission in first or second gear only when the pedal is about 1/2 way
>through its travel. If I floor the clutch pedal the first motion shaft starts
>to turn and I cannot shift into gear without grinding
>
>I cannot shift into reverse or third and forth. I could when the transmission
>was on the bench and ready to reinstall.
>
>Any ideas of what I should trouble shoot?
>
>TIA,
>John Spaur
>'62 BT7
>_______________________________________________
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|