My apologies if this message is received more than once; it seems to
have been lost on the Internet several times but my test was not.
_________________________________
I installed a lightened Denis Welch flywheel and throw-out bearing
along with BJ8 clutch disk and housing which is all supposed to work
together. However there are some issues I don't understand.
The first motion shaft will rotate in neutral which I think is normal.
When I depress the clutch pedal (it is bleed properly) I can engage
the transmission in first or second gear only when the pedal is about
1/2 way through its travel. If I floor the clutch pedal the first
motion shaft starts to turn and I cannot shift into gear without grinding
I cannot shift into reverse or third and forth. I could when the
transmission was on the bench and ready to reinstall.
Any ideas of what I should trouble shoot?
TIA,
John Spaur
'62 BT7
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|