[Healeys] Installation of FIA approved cut out switch

[Derek Job <derek.c.job@gmail.com>]

Hi all,

I've just ordered the above switch and Ive been reading up in preparation
for installation. The FIA approve cut out has 2 big terminal for the live
battery feed in and out then 2 pairs of extra terminals. One pair goes on
the circuit between the coil and the ignition switch and the other pair go
between the 'main electrical feed circuit' (as named in the instructions)
and a 3 ohm resistor to earth.

For the first pair I guess I just take the existing white wire that goes
from coil to ignition and route it from the coil to the switch and then
from the switch to the ignition.

Re the second pair, which connection would be best to acess the main
electrical feed circuit? The switch will be mounted on the dashboard.

I will remove the battery cutoff switch in the boot. Can I just simply
disconnect and remove the  black and white wire that runs from the cut off
switch to the coil?


thanks

Derek
www.healeysix.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net