Hi
I'd say it depends on how much you want the engine to rev when you
enrichen the carburettors, e.g. use the choke.
Per in Sweden
healey.nut at gmail.com skrev 2012-05-26 17:15:
> There's no real set here because it depends on how the throttle shaft has
> been drilled. Usually, however, I back off touching the lever by about one
> full turn (after slow idle fully set).
>
> ------Original Message------
> From: Dr. C. Rubino
> Sender: healeys-bounces at autox.team.net
> To: healeylist
> Subject: [Healeys] gap
> Sent: May 26, 2012 22:54
>
> What size should the gap be between the fast idling screw and the throttle
> shaft lever?
|