re: "Anyone got any idea of the tooling or technique used to make these
cutouts?"
My guess would be a jig saw or small body saw like this one:
http://www.harborfreight.com/high-speed-metal-saw-91753.html
Dumb question: do some BN1s and 2s have these cutout vents? Our BN2's fenders
only have the 3 holes for the chrome
spears' studs.
If you get a chance, I could use closeups of how the shroud is attached to the
cowl near the fascia. I know there are
pop rivets and sheetmetal screws as well as the usual 10-32 machine screws, but
we got into a frenzy disassembling our
car and didn't take enough pictures.
Bob
On 5/8/2012 7:13 PM, Michael Salter wrote:
> I have just adder 3 posts to my blog regarding the restoration of my
> earlyBN1.
> These may be of interest to some otherwise please ignore.
>
> http://www.netbug.net/blogmichael/?p=812 About the car
> http://www.netbug.net/blogmichael/?p=838 Paint history
> http://www.netbug.net/blogmichael/?p=865 Unusual front fenders
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|