You can, if you are patient and good with a hack saw and a file, cut one
out of a piece of 1/4" flat steel and, if you put a hole in the arm of it
you can hold it in place with one of the hub studs.
It works like a charm.
--
Michael Salter
Check My Blog
http://www.netbug.net/blogmichael/
--
On Sun, Mar 4, 2012 at 9:48 AM, Eberhard Pietzsch <mail at eberhard-pietzsch.de
> wrote:
> Hello,
>
> I am trying to dismantle the rear axle of my BN6. So I need
> some wrench of size 2 3/16" (about 55.5 mm). I think this
> really is the right size of the large nut in the center of
> the break housing. It has to be 8-point.
>
> Can someone help my in finding such a wrench? I already
> searched in online shops for workshop equipment but I did
> only find 12-point wrenches which shouldn't fit.
>
> Perhaps there also is an alternative tool to undo the nut.
>
> Thanks,
> Eberhard
>
>
> --
> Eberhard Pietzsch
> Tuebingen, Germany
> _______________________________________________
|