When I bench bleed, I just (carefully) pour fluid into the inlet port and
(gently) pump the pushrod until nothing but
fluid comes out the outlet port.
Am I not making this complicated enough?
Bob
On 11/5/2011 10:28 PM, Richard Kahn wrote:
> Old fittings fit new master cylinder. I cannot be the only one who is having
> this problem. I'm at the point where I will by pass the bench bleeding. What
> do the restoration shops do? I've worked on LBCs since the 70's and have
> always been able to get around the these things. This one just has me
> frustrated.
> Rich Kahn
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|