healeys
[Top] [All Lists]

[Healeys] Front A-Arm bracket location

Subject: [Healeys] Front A-Arm bracket location
From: richchrysler at quickclic.net (Rich Chrysler)
Date: Thu, 11 Aug 2011 08:44:14 -0400
References: <4E4354FB.8020107@comcast.net> <1313039736.67730.YahooMailClassic@web180609.mail.sp1.yahoo.com>
Mike, 

The frame dimensions for the front suspension mounts will be the same
relative to the shock tower, etc. as the six cylinder models and there are
basic dimensions for that in all the six cylinder manuals. Just be aware
that the mounts are canted a bit and are not quite square to the chassis
rails.
Also, can you not get dimensions from the other side?

Rich

-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at 
autox.team.net]
On Behalf Of Michael MacLean
Sent: 2011-08-11 1:16
To: healeys at autox.team.net; Bob Spidell
Subject: Re: [Healeys] Fron A-Arm bracket location

The problem is that he has already welded it in the wrong location.  I am
going there tomorrow or Friday and taking the lower a-arm assembly to use to
show him.  I just wanted a measurement to back this up.  A few years ago I
bought a frame dimension diagram for the BN1/2 from BCS, but I can't seem to
find it anywhere.  Anyone know what book this measurement may be in?
Mike MacLean

<Prev in Thread] Current Thread [Next in Thread>