The problem is that he has already welded it in the wrong location. I am
going there tomorrow or Friday and taking the lower a-arm assembly to use to
show him. I just wanted a measurement to back this up. A few years ago I
bought a frame dimension diagram for the BN1/2 from BCS, but I can't seem to
find it anywhere. Anyone know what book this measurement may be in?
Mike MacLean
--- On Thu, 8/11/11, Bob Spidell <bspidell@comcast.net> wrote:
From: Bob Spidell <bspidell@comcast.net>
Subject: Re: [Healeys] Fron A-Arm bracket location
To: healeys@autox.team.net
Date: Thursday, August 11, 2011, 4:05 AM
Mike,
I can't get you a measurement--my BN2's 90 miles away--but I have some ideas.
I have a front left bracket that's been bent a little and I've contemplated
how this could be done.
First, I think it's difficult to get an accurate measurement since there isn't
a definitive reference point, and the motor mounts are in the way IIRC. The
best way, I think, would be to tack weld some 'fingers' to the surrounding
chassis to locate the old bracket before you remove it (assuming the old is
not bent up too much). Then, you align the new bracket to the fingers, weld
it in then grind the fingers off.
Since your front bracket is already gone, you could bolt the lower spring
plate to the A-arms, mount the new bracket on the front A-arm and anchor the
rear A-arm in its bracket (sort of like using the A-arm like a compass to set
correct distance between the two brackets). That should give fairly accurate
front-rear placement, and I don't think there's much leeway on the in-out
placement (it'll be where the backside of the bracket sits flush against the
chassis rail).
Also, I don't have the shop manual here, but I think there might be a chassis
diagram that might have the measurements in it.
If you still need measurements, I'll have access to our BN2 chassis this
weekend.
Bob
On 8/10/2011 7:31 PM, Michael MacLean wrote:
> As the body of my BN2 is being finished up prior to painting, the last of
the
> welding is being done. The front left side bracket for the lower link had
to
> be replaced, but The body man welded it in the wrong place. Anyone have
any
> measurements as to where this bracket goes?
> Mike MacLean
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|