Gary
You're lucky I have my BN1 gearbox out. It has one dowel midway between
the top left hand bolt hole and the next one down (see attachment). The engine
back plate had a 3/8" tapped hole so I screwed a 3/8" bolt in that was cut
off so that only 3/16" protruded, secured it with a nut on the other side and
this lined up with the hole in the gearbox case. I can't remember what thread
the hole was but I would think it would be BSF.
Hope this helps
Don
BN1
OZ
________________________________
From: "warthodson at aol.com"
<warthodson at aol.com>
To: healeys at autox.team.net
Sent: Thursday, 14 July 2011
2:16 AM
Subject: [Healeys] BN1 transmission dowel bolts
At our local club
meeting last night, a member was inquiring about a source
for the two
transmission bellhousing dowel bolts for a BN1. I would like to
know the size
of these bolts (specifications), OE part # & a source, if
available.
Thanks,
Gary Hodson
_______________________________________________
Healeys at autox.team.net
Donate: http://www.team.net/donate.html
Suggested
annual donation $12.75
Archive: http://www.team.net/archive
Forums:
http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/healeynut at yahoo.com.au
[demime 1.01d removed an attachment of type image/jpeg which had a name of
P1020167.JPG]
|