Hi Keith, I had a similar problem recently on my BJ8 and ended up changing
the rocker bushes and rocker shaft. I did notice however after I had bought
the new bushes & rocker shaft that the oil feed pipe from the head to the
rocker shaft was loose and most likely blowing oil instead of feeding the
rocker shaft.
It might be worth taking the rocker shaft off and have a good look around at
the oil feed before replacing the bushes. I'm assuming here that the oil
feed to the rockers on the BN1 is the same set-up as the BJ8.
Kindest Regards
Tom
Tom McCay - Director, CCW-Tools, a division of Classic-Car-World Ltd, 32
Washingborough Road, Heighington, Lincoln, LN4 1RE. 01522 888178 (Tel) 0870
705 9115 (fax) enquiries@ccw-tools.com www.ccw-tools.com
Registered address: 32 Washingborough Road, Heighington, Lincoln, LN4 1RE.
Classic-Car-World Limited is a company registered in England and Wales with
company number 3930761. VAT registration number: 755 7630 05
----- Original Message -----
From: "Keith Bailey" <keithbailey5@bigpond.com>
To: <Healeys@autox.team.net>
Sent: Friday, July 08, 2011 7:06 AM
Subject: [Healeys] Oil in Cold air box
> Hi All
> I have noticed I am getting a small amount of oil in the
> cold
> air box on my BN1
> would be correct in assuming that the rocker bushes need
> replacing or are there any other
> suggestion as to how it gets there The engine as done 1000
> mile since bored and new pistons
> etc but the rockers were not touched. The engine runs and
> sounds ok
> Regards Keith
> BN1
> BT7
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
>
>http://autox.team.net/mailman/options/healeys/enquiries@classic-car-world.co.uk
>
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|