Tom,
First off, I think you're referring to the flare nut, right? How do you know
the threads are OK if you can't get the
flare nut out?
You do not want to destroy the flare nut if you can help it. Use a good
penetrating oil--soak it overnight--and it's
best to use a flare nut wrench which grips on 5 sides instead of just 2, but at
least use the proper end wrench (7/16"
IIRC). If that doesn't work you'll probably have to take vise grips to the
nut, which will ruin it, and you'll have to
fab or buy a new pipe. You might want to break the line at the hose end and do
this on the bench.
Anyway, I'm not sure what the fitting is, I think it's American/SAE--i.e. not
Whitworth--but they aren't common and your
local Napa probably won't have them (someone on the List will correct me if I'm
wrong--I HOPE). The pipe is
standard--3/16" I think--you can take it to a parts store and get a match. The
flare is, I believe, known as a 'double
flare.' You'll need a flaring tool to make them, but they're available
(usually under $20).
Moss doesn't carry the pipe alone, but they're in the kits. This place might
be able to help you:
http://www.fedhillusa.com/
Bob
On 6/18/2011 12:32 PM, Tom wrote:
> Hi,
>
> I'm removing my late BJ8's front calipers, and the nut and brake line into
> the caliper are stuck. The nut's threads in the caliper are OK, but the
> nut and brake line seem frozen.
>
> Any ideas on getting this unstuck. If I end up twisting the nut off the
> brake line, can I run to Napa and get a short piece of brake line and bend
> to fit? Or are the threads a vintage British size?
>
> thanks,
>
> Tom
> _______________________________________________
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|