healeys
[Top] [All Lists]

[Healeys] removing wire harness

Subject: [Healeys] removing wire harness
From: eyera3 at gmail.com (I Erbs)
Date: Sun, 24 Apr 2011 15:31:49 -0700
References: <BANLkTikZZyVPxXx454oKM0vxJzg_Mt47uQ@mail.gmail.com> <4DB49DB6.8090909@comcast.net>
I have a laminated color schematic, but I am color blind, so it will help
others:). I also have an offer from a Healey restorer to help me with the
re-installation.So I should be OK on that end.

On Sun, Apr 24, 2011 at 3:01 PM, Bob Spidell <bspidell at comcast.net> wrote:

> I've replaced a harness 'in situ.'  Couple things come to mind:
>
> - there's a clip on the transmission housing (somewhere) that you probably
> can't R&R with the drive train in.  I just tie-wrapped the new harness to
> the clip until I had the engine/transmission out
> - replace one connection at a time; i.e. remove the old terminal, match to
> new one, connect the new one, go to next ...
> - cut the old harness anywhere it's convenient (unless you have a good
> reason to save it)
> - the special pliers for joining connectors really help, and assure a
> better connection
> - might as well replace all the 'Lucar' connectors while you're at it
> (they're not hugely expensive).  Or, at least squeeze the old ones with
> pliers because they've been 'sprung' at least once
> - good idea to put dielectric grease in the connectors; it keeps water out
> and corrosion down
> - hopefully, you have a good schematic; you'll want to refer to it for sure
> (appendix in shop manual, or someone on the List was selling them)
>
> Have fun!
>
>
> Bob
>
>
>
> On 4/24/2011 12:47 PM, I Erbs wrote:
>
>> Good easter to the Christian listers.
>> After some health issues have caused a slow down on my restoration, I am
>> again returning to the tasks at hand.
>> I want to remove my old harness this week, and just want to know if there
>> is
>> anything I need to look out for? I know I need to cut off the dash light
>> sockets and reuse them, but what else? The dash is out of the car, front a
>> rear shrouds are in place. I plan on cutting the harness at the firewall
>> to
>> make it easier to remove, VS pulling it through.
>> Thanks
>>
>>
>
> --
> *******************************************************************
> Bob Spidell           San Jose, CA            bspidell at comcast.net
>
> *******************************************************************
>
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/eyera3 at gmail.com
>



-- 
Ira Erbs
DIGS-4 SOLUTIONS
IT CONSULTANTS
Portland, OR
      _______ Austin Healey 3000 _______
     (______ \____1960 BT7____/_______)
         (_________________________)

<Prev in Thread] Current Thread [Next in Thread>