The fourth white wire It should go to the fuel pump ?
Sent from my iPad
On Apr 10, 2011, at 5:38 PM, mike brooks <hypercubic at yahoo.co.uk> wrote:
> John,
>
> May not be relevant, but the earlier 100 BN2 diagram has the three
> wires you
> mention plus the fourth is the supply to the fuel pump. Don't know
> if this
> helps.....
>
> Mike Brooks
> '56 BN2
> Scotland
>
> Date: Sat, 09 Apr 2011
> 21:13:10 -0700
> From: john spaur <jmsdarch at sbcglobal.net>
> Subject: [Healeys]
> Fuse block terminal A3
> To: healeys at autox.team.net
> Message-ID:
> <6.2.3.4.2.20110409210804.02064938 at pop.att.yahoo.com>
> Content-Type:
> text/plain; charset="us-ascii"; format=flowed
>
> 1962 MKII BT7
>
> My wiring
> diagram shows three white wires attached to fuse block
> terminal A3. My wiring
> harness has four white wires.
>
> One goes to the overdrive relay, one goes to
> the S.W. connector on
> the ignition coil and one goes to the overdrive switch.
> The forth wire is in the wiring harness and follows the same route as
> the
> wire that goes to the overdrive switch.
>
> My original harness only had three
> white wires.
>
> What is the purpose of the forth wire?
>
> Thank you,
> John Spaur
>
> Reply to: mike.brooks at alumni.warwick.ac.uk
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/jvvmusme at yahoo.com
|