Subject: | [Healeys] BN1 100/4 standard build - Setting up engine timing |
---|---|
From: | glemon at neb.rr.com (Greg Lemon) |
Date: | Fri, 25 Mar 2011 00:54:45 -0500 |
References: | <469893.85819.qm@web87004.mail.ird.yahoo.com> |
On the top dead center it was never my understanding that the mark was at 6 degrees, thought it was at 0. If 1 and 2 are firing and 3 and four have no spark it is probably not ignition timing, that should affect all 4 cylinders, first guess and easiest is plug wires reversed on 3 & 4, if you did a rebuild and this is first start do a compression check if the wires aren't reversed, maybe a compression problem on 3-4? but that would be odd to be on both too, I think something is off in your ignition wiring from the problem as you describe it. Good luck! Greg Lemon (been there done that) |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [Healeys] BN1 100/4 standard build - Setting up engine timing, Greg Lemon |
---|---|
Next by Date: | Re: [Healeys] BN1 100/4 standard build - Setting up engine timing, Alan Seigrist |
Previous by Thread: | Re: [Healeys] BN1 100/4 standard build - Setting up engine timing, Greg Lemon |
Next by Thread: | Re: [Healeys] BN1 100/4 standard build - Setting up engine timing, Alan Seigrist |
Indexes: | [Date] [Thread] [Top] [All Lists] |