-----Original Message-----
From: bighealey3k <bighealey3k@aim.com>
To: grumpyinloomis <grumpyinloomis@ssctv.net>
Sent: Sun, Nov 21, 2010 9:25 pm
Subject: Re: [Healeys] cortina wheel bearing quesiton. NO HEALEY content
Jerry, I found this cross reference at a Timken site that says you need "Set
2" and "Set 21" for Timken or "A-2" & "A-21" for Federal-Mogul. Chicago
Rawhide would be "BR2" & "BR21". I have an old SKF catalog that calls out
"NO. 2 SET & NO. 21 SET" I hope this helps.
Here is the Timken link:
http://pdf.directindustry.com/pdf/timken-europe/bearing-and-seal-application-
catalog-for-automotive-and-light-truck/7626-147227-_581.html You can see the
bearing numbers you referred to are there except the small bearing starts with
"LM" not "LH".
Good luck,
Larry '67 BJ8
-----Original Message-----
From: Jerry Costanzo <grumpyinloomis@ssctv.net>
To: healeys <healeys@Autox.Team.Net>
Sent: Sun, Nov 21, 2010 3:51 pm
Subject: [Healeys] cortina wheel bearing quesiton. NO HEALEY content
Group,
I have a 1967 Cortina which has two different sets of wheel bearings listed
or this year. I have measure the old bearings and know that they are 19mm
nside for the small bearing and 28.58 for the large bearing. They are
imken bearings with the following numbers:
mall LH 11949
arge 1988
Anyone have a conversion to SKF so when I walk into NAPA, I get the right
art?
Jerry
N4
J8
ord Cortina 1967 sans engine , transmission, brakes, interior, windshield,
ood, etc.
______________________________________________
ealeys@autox.team.net
onate: http://www.team.net/donate.html
uggested annual donation $12.75
rchive: http://www.team.net/archive
orums: http://www.team.net/forums
nsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/bighealey3k@aim.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|