All -
I may have asked this before, but are any of you aware of anyone that might
sell the finishing crimpers for the solder bullets - if you look at your OEM
harnesses you will see that most of the bullets have a really nice rounded
back end to them.
Most suppliers still sell the bullets, but I can't seem to find anyone who
sells the crimper that folds the back end of the bullet so nicely against
the wire's insulating sleeve.
I'm a bit of a stickler when it comes to wiring so I was hoping someone out
there might have an idea.
I have a proper hex crimper for the crimp type bullets, I don't need one of
those.
Best Regards,
Alan
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|