IIRC, the rails are galvanized. If you weld on them be sure to use a
respirator in a well-ventilated area--the fumes
will be very toxic.
http://www.anvilfire.com/iForge/tutor/safety3/index.htm
bs
On 10/12/2010 7:18 AM, Jean Caron wrote:
> Rick:
>
> I use bolt of the same size but prior to welding them in place, I grind off
> about half of the thickness of the head and then weld them in place.
>
>
>
> Jean Caron
>
>
>>
>> While removing the T nuts from the bottom of the seat rail, the studs
> passing
>> from the bottom of the rail, through the floor and secured by the T nuts
>> snapped off. They are flat headed. Anyone know a fix for this?
>>
>> Thanks,
>>
>> Rick
>>
>>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|