healeys
[Top] [All Lists]

Re: [Healeys] rocker shaft assembly

To: "David Z" <davzu29@cox.net>, <Healeys@autox.team.net>
Subject: Re: [Healeys] rocker shaft assembly
From: "John Snyder" <helyjohn@cablespeed.com>
Date: Thu, 27 May 2010 19:01:25 -0700
You should contact "Rocker Arm Specialist"  email = rocker@c-zone.net.   He 
is in Anderson, CA.  He has done at least 4 for me, and they are very good 
quality.  ph = 1-530-378-1075.

John Snyder


----- Original Message ----- 


>I purcased a replacement rocker shaft assembly for my BJ8 due a bit lower 
>than
> normal oil pressure, oil in the rear air cleaner and squirting up from a
> couple of the rocker arms. What is the suggested torque for the rocker arm
> nuts? I know to be careful about applying too much torque to the oil 
> supply
> line. Can I re-use the copper washers on either side of the banjo fitting, 
> or
> do I need to get new ones?
>
> Thanks!
> David Z.
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>