Hello all,
I checked the archives, but could not locate any info:
I will be converting my BT7 heavy duty clutch to the softer BJ8 setup. I'm
looking for a template for relocating the pins/bolt holes on the BT7
flywheel. It is a lightened wheel, so I do not want to swap it out for a BJ
8
Thanks.
If you have done this before, please reply with cautions and encouragement
:)
--
I Erbs
Portland, OR
_______ _______
(______ \____1960 BT7____/ _______)
(_________________________)
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|