Tom
One thing with cutting the holes with a knife. If a grommet has to be
inserted in the hole in the firewall the extra thickness of the tar
paper/felt may make it difficult to fit the grommet. Original cutouts
were over sized. Some holes are in the tar paper just to clear the
welded nuts on the back of the firewall. I found it just as easy to
make a paper template and then cut or punch the holes using it as a
guide on the tar paper. All the best.
Aloha
Perry
Tom wrote:
Rob,
Many thanks for the tip. Especially helpful since likely not to have all
right hole punch sizes.
Tom
On 4/24/10 2:18 PM, "robert westcott" <55healey@comcast.net> wrote:
> A good sharp exacto knife works well once it's in place, just carve
> around the inside of the edge of the hole.
>
> Rob
>
> On Apr 24, 2010, at 8:29 AM, Thomas Morrione wrote:
>
>> I hope that a friend in an art supply store's right saying paper hole
>> punches he has will work -- if not, you're right -- lot's of
>> patience. I've
>> never worked with Dynamat before. Am inspired by Dynamat use and
>> restoration
>> pix of "Andy's Healey" at
>>
>> http://www.austin-healey3000.com/interior.htm
>>
>> Tom
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|