Elton, disconnect the vacuum hose if you haven't already, there should be a
circlip or wire clip on the vernier fine adjustment wheel on the small end
of the piece, remove this (without losing it if you can) and unscrew the
vernier adjuster all the way off. Take off the dist. cap and rotor, there
is a spring that goes on a peg on the sliding plate the spring is what is
connected to your diaphragm and adjusts your timing. Anywho it just loops
over a peg on the sliding plate, pull it off with a hooked wire or small
screwdriver and the piece should just slide out. Greg Lemon
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|