Simon.
Off the top of my head, the only common BSW thread on most Healeys is the
front generator support bracket which uses a 5/16 BSW bolt into a threaded
hole in the aluminum front plate of the generator.
The confusion with the 5/16 BSW thread is that it has the same threads per
inch as the 5/16 UNC thread (Most BSW have the same TPI with UNC except for
1/2"), therefore this bolt will screw in but it's not correct and SHOULD NOT
be used. Why? Because Whitworth fasteners, by definition have a 55 degree
pitch angle on the threads while Unified fasteners are 60 degrees.
And yes, if you have a 100-6 or early 3000 this bolt will have been
Whitworth. Even my Bugeye Sprite has a 5/16 BSW bolt in this spot.
Anyone know of other BSW applications on other that the 100s?
Curt Arndt
Carlsbad, CA
'55BN1, '60 AN5 :{)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|