I have the front shroud off my 1959 BN7, easy to measure, and the holes are
3/4", and level.
John Snyder
> Hard to get a tape or whatever in there, but mine are, on average, 3/4in
> from the top of the bit of metal into which they are drilled. On average?
> Now that I look very closely, mine aren't exactly level!
> Take a number of measurements from the group and make your own average?
> Simon
>
>
> Team.
> I have done my penance and searched the archive for a post that featured
> not
> so long ago. As usual I came up empty and therefore seek your guidance.
> The
> bonnet latching mechanism is mounted on a bracket held with two screws to
> the front panel at the top of the cross-brace. During the chassis
> restoration of my BN4 the top panel was replaced and it doesn't have the
> holes or captive nuts in place to fix the bracket to. Can someone advise
> (remind me) how far down the screw holes should be?
>
> Many thanks
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|