Mark,
If it has a diode just test it and if it's still good reuse it. If it has a
condenser (capacitor) or nothing, I'd get the diode.
You might want to replace the diaphragm while you're at it.
bs
--------------------------------
Bob Spidell - San Jose, CA
Lister,
I want to rebuild an older SU fuel pump, positive ground, points type,
from my BJ8. The pump was a Moss replacement for the original back in
@1980. For what's it worth, the only identification numbers I can
find on the pump are on an SU sticker label. The numbers are SU 940
and AZX 1318. On page 35 of the current Moss catalogue both a
Condenser (line item 31) and a Diode (line item 31a) are listed as
part numbers 377-110 and 377-135, respective. Am I correct in
assuming the electrical part I will want to replace is the positive
ground diode, line item 31a. ? In addition I plan to replace the
points.
Marks3
'66 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|