Moss part# 157-107 for the connectors.
Have never seen any (authentic) parts for horns (inc. the rubber plate).
bs
Bob Haskell wrote:
> Thomas,
>
> The connectors are the same style as those used inside the license
> plate lamp. They look like an elongated bell. Strip the insulation
> off the wire, feed the wire up through the bottom of the bell until
> the bare wire sticks through the top. Fold the bare wire over,
> spreading it out around the bell and insert the connector into the
> socket.
>
> Bob
>
> Thomas Willig wrote:
>> Hello,
>>
>>
>>
>> I need advise on the following questions about Lucas Altette Horns:
>>
>>
>>
>> 1. How are the wires from the wiring loom attached to the horns? Bullet
>> connectors maybe? Who sells these connectors?
>>
>> 2. Does someone sell the rubbers, isolating plate and steep plate which
>> hold the electrical connectors in place?
>>
>>
>>
>> Thanks
>>
>>
>>
>>
>>
>> Thomas Willig
>>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|