This is something that I personally have never attempted but it sure makes a
lot of sense.
It was suggested that I unbolt the front u-joint from the trany in order to
isolate a
clunking noise coming from that area. This would certainly rule out noise
from
the U-joint going back to the rear end.
So can I just sit in the car and run through the gears and RPMs without the
drive shaft
connected and not screw up anything. It sounds too easy.
Sure hope the neighbors are away or they may think I have lost it. My wife
already has
taken this view point.
Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|