Check to see that a carb needle(not a float needle) has not come loose and
become seperated from the piston - been known to happen.
Best
JK
--- On Fri, 9/4/09, wwscpo@aol.com <wwscpo@aol.com> wrote:
> From: wwscpo@aol.com <wwscpo@aol.com>
> Subject: [Healeys] Different Carb Problems
> To: healeys@autox.team.net
> Date: Friday, September 4, 2009, 1:27 PM
> Hello List
>
>
>
> My BJ8 just wont respond under load.? It starts
> immediately. The dwell is correct as is the timing. It idles
> at around 800 rpm.? The floats are working, the carbs are
> syncronized for vacuum.? It accelerates without hesitation
> while in neutral and I rev the engine.? As soon as I put it
> in gear it sputters and doesn't really respond at all.?
> Wrong size needles?? Your advice please.
>
> Thanks
>
> Bill Schumann
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as jackson_krall@yahoo.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|