While I haven't removed many Healey engines (mine 3 times and one other) I did
have a problem the last time. I had removed and replaced the engine alone
twice using therocker shaft/valve cover studs - no problem. I have the BMC
lifting brackets. This last time I lifted both engine and gearbox together -
again using the valve cover studs. No problem. However, when I went to replace
the engine and gearbox unit I had some trouble tightening the nuts down. It
appeared that the studs may have stretched - I was using two new nuts on each
stud.
I pulled the rocker shaft and used head studs instead - just in case. I bought
new valve cover studs.
Rick'59 BN4
> In reply to the question if anyone else has had this happen, then no, we
> have not. However we always tighten the lifting bracket down onto the top
> of the nut holding the rockershaft. That way there is no slop and no area
> for bending/shearing. The lifting capacity of the studs is probably many
> times the weight of the power unit.
> Cheers.......Bob
> Check out our web site www.autofarm.net
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as rjswain@hotmail.com
>
> http://www.team.net/archive
_________________________________________________________________
Send and receive email from all of your webmail accounts.
http://go.microsoft.com/?linkid=9671356
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|