healeys
[Top] [All Lists]

[Healeys] Fw: healey motor/gearbox measurements

To: "Healeys" <healeys@autox.team.net>
Subject: [Healeys] Fw: healey motor/gearbox measurements
From: "Rich C" <richchrysler@quickclic.net>
Date: Sun, 5 Jul 2009 20:15:51 -0700
Rick, et al,

I thought I was losing my mind so I just went out and checked the heights on a
26D series and a 29K series and used a straight edge across the bottom of the
pan on each engine (both engines are sitting in stands) and measured to the
top of the T breather pipe. Both measured within 3/16" of 27" total height.
Variation was due to one of them having the T pipe screwed in a bit further
than the other.
And that's measurements taken using the Queen's Imperial measuring system.

Rich
  ----- Original Message -----
  From: HealeyRick
  To: Linwood H Rose ; healeylist ; Rich C
  Sent: Sunday, July 05, 2009 3:12 PM
  Subject: Re: [Healeys] healey motor/gearbox measurements


        On my 29Dthe height from the lowest part of the oil pan to the top of
the T was more like 29", everything else matches Rich's dimensions.  Perhaps
Rich was measuring height in Canadian inches and I was measuring in American
inches?

        Rick


          Lin,

          A couple of weeks ago a good portion of the list members were
heading to Conclave!

          - height from bottom of oil pan to top of T pipe on rocker cover
27"
          - length from fan centre to engine back plate 33 1/2"
          - length from fan centre to end of propshaft on gearbox/od 64"
          - Width from distributor across to air cleaners approx. 25".

          Rich Chrysler

          ----- Original Message ----- From: "Linwood H Rose"


          > Hi folks
          > I posted this a couple of weeks ago without a response. Thought I
would try one more time before I give up. Thanks!
          >
          >
          > Does anyone have linear measurements for the engine with usual
components attached? Or, if there is a document like the frame  "blueprint"
you can refer me to, I would appreciate it. I am looking  for things like
height from bottom of oil pan at lowest point to the  top of the rocker cover
(or the vent "T" pipe on the cover), depth  from fan center to engine
backplate, depth from fan center to end of  the gearbox, width of the block
and width from the air cleaners to the  distributor (widest point of the
assembly)
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>