One of my front fenders has an "oil canning" dent that needs some attention.
When
popped out it will eventually pop back in. This is in the largest field area
of the fender and is obviously very noticeable.
This was created by either too much abrasive blasting or too much heat when
the lower panel was welded on.
Can this be filled in with a good firm body filler and expected not to pop out
at sometime
down the line.
Mark
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|