Hello,
I need advice:
Is a die grinder suitable for limited cutting of sheet metal healey
parts such as cutting out part of the boot bump boxes or should I be
using a cut-off tool? I don't need to do a lot of cutting about,
about 70 lineal inches, but I will need to grind quite a few welds.
Conversely would the cut-off tool, with the right stone, be
appropriate for grinding down welds?
This is stuff I have to buy.
Thank you,
John
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|