I have successfully used JB Weld to seal pin hole leaks at the other end -
near the tail pipes (I run free-flow Monza pipes) . It doesn't get nearly as
hot back there as at the manifold, but I have had no problems since I sealed
them in the past three years.
Randy
On Mon, Jun 1, 2009 at 10:13 AM, John Sims <ahbn6@verizon.net> wrote:
> Can J B Weld be used to repair a small pinhole or crack in an exhaust
> manifold?
>
> John Sims, BN6
> Aberdeen, NJ
>
> http://www.healey6.com
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as 1968xke@gmail.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|