Graham:
Thanks - this info helps greatly! As it now develops, we will be pulling
the flexible hoses off of a friends BJ8 in the next few days - we're pretty
sure that the hoses are original (believe it of not).
If it turns out that there is any substantial difference in the
measurements, I will post to the list. I believe from what I have here,
that your measurments are correct.
Thanks again, --------- Earl
----- Original Message -----
From: "Graham and Lorraine Wilkie" <glwilkie@bigpond.com>
To: "Earl Kagna" <kags@shaw.ca>; <healeys@autox.team.net>
Sent: Friday, May 22, 2009 9:30 PM
Subject: Re: [Healeys] Brake Hoses ---
Hi Earl,
Assuming that Moss sent me the correct BJ8 hydraulic flexible hoses
(these are new and not yet installed), their lengths are as follows:
2 front brake flexible hoses (each): 13 1/8" (333mm).
Rear (axle) brake flexible hose: 12 9/16" (320mm).
Clutch flexible hose: 9 3/4" (248mm).
I hope that helps you figure out what you have there.
Cheers, Graham Wilkie.
HBJ8L / 32382
Earl Kagna wrote:
> Fellow Listers:
>
> Anyone happen to know the correct lengths of the flexible hydraulic hoses
> on
> a BJ8? (earlier sixes should be the same). I have a bunch lying around
> and
> I'm trying to figure out what their applications are. (TR6 hoses are
> pretty
> close as I recall). This would include the 2 front calliper hoses, the
> rear
> axle hose, as well as the clutch slave hose.
>
> Thanks in advance.
>
> Earl Kagna
> Victoria, B.C.
> BT7 tri-carb
> BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|