I got a new cable from Healey Surgeons that locks with a twist. It
does say "choke" instead of "C" but it works just fine.
Bob Johnson
BJ8
On Wed, May 6, 2009 at 2:12 PM, Earl Kagna <kags@shaw.ca> wrote:
> We're working on a BJ8. Has anyone tried to resuscitate the original
> primary cable assembly - in order to retain the twist-lock feature? The
> replacement cable assemblies are a pull out friction deal that everyone
says
> does not work very well - we do have one in hand if necessary.
>
> On our car, the inner cable end has been frayed and repaired (as usual) and
> is now too short - leaving us with not enough cable to fully choke the
> carbs. I'm thinking that a fix might be to somehow 'sweat' the cable out
of
> the knob assembly, and simply solder a replacement length of bicycle cable
> in, without destroying the plastic knob with heat. We have absolutely no
> extra length to the cable housing, so shortening that will not work to give
> us our extra travel. Carbs are off the car right now for rebuild, so now
is
> the time.
>
> Anyone had any experience with this? Any and all input appreciated.
>
> Earl Kagna
> Victoria, B.C.
> BT7 tri-carb
> BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as bjsbj8@gmail.com
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|