Stephen,
You will have to remove the roll pins from both ends of the slider track to
release the steel balls from both ends. There are little detent pressings in
the upper female track that prevent the balls from going all the way through
from one end to the other, so the balls need to come out both ends.
Rich Chrysler
----- Original Message -----
From: "Stephen Hutchings" <s.hutchings@rogers.com>
To: <healeys@autox.team.net>
Sent: Thursday, April 30, 2009 5:54 PM
Subject: [Healeys] Seat slider mechanism
> I'm having trouble separating the seat slider mechanism (BJ8).
> I thought it was the little peaned over pin in the end of the half that
> gets bolted to the floor, but there is still something preventing it from
> sliding out.
> So, what's the procedure?
>
> Stephen, BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|