Good to know. Thanks.
Got me to wondering if anybody has a list of which fasteners are which type on
our Healeys (think Norman's Tech Book has a list of equivalencies, but don't
remember if there's a list of which fastener goes where). My father and I have
been, uh, surprised by some UNF threads in places we didn't expect (near-match
SAE nuts will go on easily for about half the diameter of the thread then jam).
Bob
Craig and Sue Rice wrote:
> Bob,
> Fuel fittings are British Standard Pipe (tapered thread) or British Standard
> Pipe Parallel (straight thread). I don't believe any Whitworth was used in
> fuel lines or components.
> Craig Rice
> BN1 & BN2
> ----- Original Message -----
> From: "Bob Spidell" <bspidell@comcast.net>
> To: <robertlarson@att.net>
> Cc: <Healeys@autox.team.net>
> Sent: Tuesday, April 28, 2009 9:03 PM
> Subject: Re: [Healeys] Stripped Outlet on Fuel Pump
>
>
>> I just made a (rough) measurement of the threads on one of my (many) spare
>> pumps. From inside of thread to inside of thread is about 9/16" give or
> take.
>> It does not appear to be a pipe thread.
>>
>>
>> bs
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|