Mark,
These brackets attach onto the bottom left and right studs of the grille
assembly, along with the tabs of the grille teeth and the bottom of the air
shroud that directs air to the radiator. It's quite a sandwich of parts that
all mount to the same studs. These splash shields mount after the grille
assembly is basically in position. That way the grille teeth assembly can be
brought in from the side.
Rich Chrysler
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Mark LaPierre
Sent: Tuesday, April 21, 2009 4:10 AM
To: healeys@Autox.Team.Net
Subject: [Healeys] Where Does it Go? Question
Parts manual calls it the "splash panel steady bracket". ( Page R9 &
R10,,,,
#2) There is one for each side of the car.
One end screws to the lower splash panel, where does the other end connect
to?
I have looked in every Healey book that I have and this is a bit of an
unobtainable area that is
difficult to photograph with everything intact.
In fact there is a picture of them dangling from the front end of the red
Healey on the front
cover of April Marque magazine. But of course the one end is not attached
to anything
since the shroud is off.
Thanks, Mark
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as richchrysler@quickclic.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|