For those of you who are looking for various products produced by Doug
Reid, aka Mr Finespanner
they are found in the technical section of
www.vintage-sportscar-touring.ca as it an e-mail link
to Doug. In addition there are a series of technical articles written
by Doug that are worth a read.
Kind regards
Ed
Historian, AHCUSA
Saskatoon, Saskatchewan
'53 BN1 '65 BJ8 '89 Morgan 4/4
John Sims wrote:
> OK. Here's the deal. For about 35-40 bucks you can buy the clutch slave
> cylinder bleed extension which will, in the future save you a lot of
> aggravation as you will then be able to bleed from inside the engine
> compartment with no strain or pain. This extends the bleed line to above the
> oil filter. Email Doug Reid at: mrfinespanner@earthlink.net. I would suggest
> that you go ahead and get this before you start to bleed if you are willing
> to wait a week or so. Then, use a speed bleeder at the tip of it and you can
> bleed by yourself. No financial interest, yadda yadda yadda just a very
> happy customer of Doug's
>
> If you want to do it right now, you can get to the bleeder by pulling your
> tranny cover or by underneath the car but you need small fingers.
>
> John Sims, BN6
> Aberdeen, NJ
>
> www.healey6.com
>
>
> -----Original Message-----
> From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
> On Behalf Of STOCKLAND@aol.com
> Sent: Sunday, April 05, 2009 12:11 PM
> To: healeys@autox.team.net
> Subject: [Healeys] BJ 8 Clutch Question
>
> Just replaced the flexible hose to the clutch slave cylinder and now I need
>
> to bleed the system. However, I cannot get to the bleed screw. Is there
> some technique I am missing? Thanks for your suggestions.
>
> Jon
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|