Keith,
Originally there is a small diamond shaped relief in the original toe board
panel to allow exactly the relief needed for this. If your toe board panel
has been repaired or replaced, you'll need to carefully tap the metal back
(toward the inside of the car) to gain this relief. It is about 1/4" offset.
See pictures.
Rich Chrysler
----- Original Message -----
From: "Keith Bailey" <keithbailey5@bigpond.com>
To: <Healeys@autox.team.net>
Sent: Wednesday, February 18, 2009 2:19 AM
Subject: [Healeys] Break Pedal
> Hi All
> I am experiencing a problem with the break pedal an my BN1 on the
> pedal assembly the short arm that connects to the master cylinder hits the
> foot well thus not allowing the pedal to be in the fully off position. The
> approx length of this arm 3 inch if I were to shorten by about 1/2 inch
> and re
> position the hole that connects to the push rod brake master
> cylinder .Does any one see a problem
> Regards Keith
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Easter 05 Plus Work 086.jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
4Jan09 022.jpg]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|