Simon,
The front muffler mount does not fasten to the outrigger. It is fastened to
the driver's floor board, behind the outrigger, with two bolts 5/16"
diameter by about 1" long, that sit side by side, whose hex heads will be
inside the car, under the carpet underlay and tar paper lamination. Under
the car, these will hold the front metallastic exhaust mount with
lockwashers and nuts.
Sorry I don't have that model in the shop at the moment (any six cylinder
model except the BJ8) so I can't give you any location dimensions. However
if you assemble the complete system loosely so you can make small
adjustments to everything it will soon become obvious where the mounting
bolts need to be.
Rich Chrysler
----- Original Message -----
From: "Simon & Christine Atkinson" <satkinson7314@charter.net>
To: "Healeys" <healeys@autox.team.net>
Sent: Thursday, January 01, 2009 7:21 PM
Subject: [Healeys] front muffler mounting point (Bt7)
> In test fitting my new exhaust today I noticed that I do not have a
> mounting
> location for the front of the muffler (silencer to some other folks). The
> mounting bolt on the muffler is close to the front outrigger which leads
> me
> to think I'm missing the same mounting holes as on the rear outrigger?
>
> Any pics or advice would be appreciated.
>
> Thanks,
>
>
>
> Simon
>
> 1959 BT7L
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|