Jerry,
1. Safety hooks on the bonnet are body colour.
2. Rubber split bonnet rubbers are fastened on by split rivets with washers
under the head going outboard with heads inboard, through the longer half of
the rubber, through the shroud flange, the ends then being spread flat. The
easiest way to do this is to begin with the rubbers turned completely upside
down, installing the rivet and spreading it flat, then carefully turning the
rubber around to right side up, making sure the outer half is eased into the
shroud flange trough.
Rich Chrysler
----- Original Message -----
From: "Jerry Costanzo" <grumpyinloomis@ssctv.net>
To: <healeys@Autox.Team.Net>
Sent: Sunday, December 14, 2008 9:59 PM
Subject: [Healeys] questions on BJ8 restore
> Hello List, I have a few questions for you.
>
> 1. What color are the safety hooks on the bonnet? I assume body color?
>
> 2. The rubber hood bumpers around the front shroud opening. Are they
> held on
> by split rivets or regular rivets? Does this rivet go through from the
> outside
> to engine side or vice versa?
>
>
>
> Comments on new parts:
> I just installed a repo rear bumper on new bumper brackets. They required
> a
> lot of adjustments to make them fit together. I also noticed that license
> plate/light holder did not fit on the bumper.
>
>
>
> Jerry
> BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
[demime 1.01d removed an attachment of type image/jpeg which had a name of Gino
BJ8 (31).jpg]
[demime 1.01d removed an attachment of type image/jpeg which had a name of
Oct08 012.jpg]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|