If you hold a hinge up with the pin horizontal looking at the end you will
note that the lower surface slopes slightly.. that's how I tell.
Some have LEFT or RIGHT cast into them but that is too easy.
Michael Salter
100 (1953) #174
AHX12 (1953)
Bugeye (1961)
http://www.netbug.net/blogmichael/?p=432
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of David Schweninger
Sent: December 8, 2008 6:18 PM
To: pennell@cox.net; Healey Mail List
Subject: Re: [Healeys] Luggage Rack
Keith,
What defines a left or right hinge? I can't believe the pin holes were
drilled crooked.
Dave and Daisy
On Dec 8, 2008, at 5:46 PM, <pennell@cox.net> wrote:
> Unless the left and right hinges were reversed when installed?
> Suspect this would stress the holes right much and ream the wholes
> to make them sloppy.
>
> Keith Pennell
>
>> As for the holes in the hinges wearing thin, the only wear possible
>> would be
>> each time the hinges pivot, and I can't imagine that being too
>> frequently.
>>
>> Rich Chrysler
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|