This is what I am going to try;
All the wholes on the inside of the trunk correspond to the wholes underneath.
Instead of rivets, I put in screw, washer, a rubber washer, spacer, another
washer then a nut. All of them are at an angle pointing out towards that back
end if the car. I think if I push out the trunk so all the screws are strait
down, the trunk lid should fit. I am also going to bring my trunk lid over to
a friends place to see if the trunk curve is starter then it was originally.
I thought of this after seeing the curve on the back part of the hood was
straightened after 20 years of sitting in the rafters. The trunk lid probable
did the same thing
Thanks,
Ron
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|