Probably cam bearings installed wrong. But I would remove the rocker
assy first and crank the engine over and see if oil comes out of the
oil fitting in the head. Then remove the head and crank it over again
and see if oil is being supplied to the head, if not then the cam
bearing is installed wrong.
There also is a possibility that the plug in the oil gallery inside
next to the oil pump is missing. If pull the pan and look up next to
the oil pump there is a oil gallery that should have small bolt with
a copper washer sealing a hole.
David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767
www.britishcarspecialists.com
|