Is there any secret or trick to aligning the catches on the door frames to the
closing mechanism on the door? My frames were replaced in the restoration of
the body. The pre-drilled holes in the door frames seem to be about 3/4 of an
inch too high. The door is perfectly aligned with the other body panels, so
moving the door to align with the catch would throw off the lines of the car.
The only solution I see is to drill new holes in the door frames. Is there any
alternative?
Thanks in advance for your thoughts.
Bill
Bill
Boston area
'65 BJ8
'02 S2000
'06 330i
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|